旋紧紧力螺栓。所有紧力螺栓均需用力矩板手按标明的固定扭力矩数据进行固定和检查。减速机与机械设备间的正确安装类同减速机与驱动电机间的正确安装。关键是要必须保证减速机输出轴与所驱动部分轴同心度一致。

Tighten tight bolt. All tight bolts must be fixed and checked with the fixed torque data marked by the torque plate hand. The correct installation between the reducer and the mechanical equipment is the same as that between the reducer and the driving motor. The key is to ensure that the output shaft of the reducer is cistent with the of the drive shaft.

减速机与工作机的联接：减速机直接套装在工作机主轴上，当减速机运转时，作用在减速机箱体上的反力矩，又安装在减速机箱体上的反力矩支架或由其他方法来平衡。机直接相配，另一端与固定支架联接.

The connection between the reducer and the working machine: the reducer is directly installed on the main shaft of the machine, when the reducer operates, the torque acting on the gearbox body is installed on the reverse torque support on the reduction box body or by other methods to balance. The machine is directly matched and the other end is connected with the fixed support.

允许输入法兰：

不能大于或小于临级减速机的标准尺寸，如减速机PLE80?的标准法兰为80mm,其临级的减速级是PLE60?和PLE120，PLE80?允许法兰不应小于60mm,也不能大于120mm。

Allow input flange

It can't be greater than or less than the standard of the reducer. For example, the standard flange of reducer PLE80 is 80mm, and the deceleration stage of its reducer is PLE60? PLE120, PLE80?对减速机箱体进行共振测试，找出共振位置，增加适当的筋条（板），可以提高箱体的刚度，减少箱体的振动，实现降噪。 The maximum allowable flange should not be less than 60mm, nor greater than 120mm.

减速器是一种由封闭在刚性壳体内的齿轮传动、蜗杆传动、齿轮-蜗杆传动所组成的***部件，常用作原动件与工作机之间的减速传动装置 。在原动机和工作机或执行机构之间起匹配转速和传递转矩的作用，在现代机械中应用极为广泛。

The reducer is an independent component of gear tran***ission, worm drive and gear worm drive enclosed in a rigid shell. It is often used as a deceleration between the original and the working machines. The matching speed and transfer torque between prime movers and working machines or actuators are widely applied in modern machines.