旋紧紧力螺栓。所有紧力螺栓均需用力矩板手按标明的固定扭力矩数据进行固定和检查。减速机与机械设备间的正确安装类同减速机与驱动电机间的正确安装。关键是要必须保证减速机输出轴与所驱动部分轴同心度一致。

Tighten tight bolt. All tight bolts must be fixed and checked with the fixed torque data marked by the torque plate hand. The correct installation between the reducer and the mechanical equipment is the same as that between the reducer and the driving motor. The key is to ensure that the output shaft of the reducer is c***istent with the of the drive shaft.

通常齿轮减速机已广泛应用于冶金、矿山、起重、运输、水泥、建筑、化工、纺织、印染、制药、等领域。但在这种齿轮减速机的使用有一定的限制,所以,让我们了解下使用时需要注意什么。

1、高速旋转不超过1500 r / min。齿轮减速器。

2、齿轮圆周速度不超过20 m / s。

Usually gear reducer has been widely used in metallurgy, mining, lifting, transportation, cement, c***truction, chemical, textile, printing and dyeing, pharmaceutical, and other fields. But there are some restricti*** on the use of this gear reducer, so let us know what to pay attention to when using it.

1. The high speed rotation does not exceed 1500 R / min. Gear reducer.

2, the circumferential speed of the gear is not more than 20 m / S.

减速机的作用

1)降速同时提高输出扭矩，扭矩输出比例按步进电机输出乘减速比，但要注意不能超出减速机额定扭矩。

2)速同时降低了负载的惯量，惯量的减少为减速比的平方。大家可以看一下一般电机都有一个惯量数值。

The function of the reducer

1) reduce the speed and increase the output torque at the same time. The ratio of the torque output to the multiplying and decelerating ratio of the stepper motor output, but we must be careful not to exceed the rated torque of the reducer.

2) speed reduces inertia of load at the same time, and inertia reduces to the square of deceleration ratio. As you can see, general motors h***e an inertia value.