余压探测器前室微压差压力传感器供应商

德州紫旭豪鲁邦消防应急疏散余压控制器消防应急疏散余压控制器

CR-YYKZ消防应急疏散余压控制器

1、完全满足《建筑防排烟系统技术规范》；

2、可监控疏散通道上余压、以PID控制方式控制泄压阀，调节余压在安全范围内；

3、向监控主机反馈现场工作状态，联动余压传感器调节泄压阀；

4、现场就地取消防电源作为工作电源，可以灵活构建大容量余压监控系统；

5、每个回路可带载128只余压传感器；

6、可以持续调节泄压阀的开启角度。

前室压力探测器前室微压差压力传感器供应商

When the supply air volume and time of itive pressure air supply system is out of control, the normal escape route may be too high because of the itive pressure of the front room, the fire door can not open the serious cequences. In view of the above ciderati, the Sichuan Institute of Fire Science combined with experience to provide data of residual pressure value. By controlling the opening and closing of the by-pass Valve, the differential control system can effectively control the residual pressure of the mechanical pressurized air supply system within the reasonable range required by the national standard ——40-50 PA in the ***oke-proof Stairwell, the front room, the shared front room, the front room of the fire elevator room and the enclosed refuge floor (room) are 25-30Pa.

前室压力传感器

の467565du7674i5ud7d65d7udii5防烟楼梯间压差测控系统；室内外压差检测、过滤网堵塞监控系统等干燥气体的压差测控系统。本产品整体采用四线制连接，安装时将每个单元中的压差控制任一产品出现损坏均不影响其它产品正常运行。tgfrtydthhhysthyddddurijfytrr6tjy5uyttyyyyyyyjffgmjgjghkhlhlhlhlh

压力传感器

Product Features are: 1: The use of sensing technology, core components imported core body. 2: And Directly Change The sensor signal into changeable passive switch signal with microprocessor circuit. 3: Output Action Point * * * , High repeatability. 4: This product with new technology to reset the process can be any user requirements.

产品特点有:

1:采用传感感应技术,部件采用国外进口芯体.

2:并用微处理电路直接把传感器信号变成可更改的无源开关量信号.

3:输出的动作点***,重复性高.

4:本产品着新技术让复位过程均可按用户要求任改动.