武汉螺耐斯-莫诺定子
作者:螺耐斯2020/8/15 3:32:45






定转子过早磨损Premature wear of fixed rotor定转子过早磨损主要是由于定转子的间隙过小引起的。The premature wear of the fixed rotor is mainly caused by the ***all gap between the fixed rotor and the rotor.油管与抽油杆柱磨损Oil pipe and rod string wear油管与抽油杆柱磨损的原因一是因为井斜抽油杆贴在油管壁上引起的,可以通过加抽油杆扶正器使抽油杆柱居中来减轻或消除,另一个原因是定转子不同心及转子的偏心运动造成的,在定子以上加一节内径较大的回转筒即可避免。Tubing and sucker rod wear reason is because the deviation of sucker rod attached to the tubing wall caused by heating, pumping rod centralizer make the rod center to reduce or eliminate, another reason is caused by the eccentric motion of the rotor and the rotor are not concentric, ***oid a day the diameter of rotary cylinder in the stator can be larger than.



单螺杆泵类别: 泵从大类分为两种:容积泵和流量泵。 容积泵:通过泵的传动部件形成的空腔转运流体,传动部件的转动移出流体分为往复式和旋转式两大类 流量泵:带给流体动能,流体转运和循环;不允许干运行,莫诺定子,液面以下运转单螺杆泵特点: 1、在低转速工况下压力稳定 2、低必须气蚀余量 3、可输送含大颗粒的介质 4、可输送含磨蚀性的介质 5、压力可至48B 6、流量稳定、可用于计量加药 7、流量对介质的粘度高低影响不大 8、只有一处轴封、便于检修



D、限位器D, limiting device限位器为一个底部带限位板和流通通道的短节,接在定子的尾部,其作用是施工作业时给转子限位以防止下入过头而失去作用和杆柱脱落时防止杆柱掉入井底。The limiting device is a short section with bottom limit plate and distribution channel, which is connected to the tail of the stator. Its function is to limit the rotor to the rotor during ctruction1, so as to prevent it from falling into the overhead and lose its function and prevent the rod from falling into the bottom when the rod string falls off.



武汉螺耐斯-莫诺定子由武汉螺耐斯环保设备有限公司提供。行路致远,砥砺前行。武汉螺耐斯环保设备有限公司(www.hbronice.com)致力成为与您共赢、共生、共同前行的战略伙伴,与您一起飞跃,共同成功!

商户名称:武汉螺耐斯环保设备有限公司

版权所有©2025 产品网