混流泵
轴套用来保护轴不使它与填料直接摩擦,若长期使用中发现轴套磨损过多,必须换轴套。
IV. Axile sleeve is used to protect the axle from friction
with padding.In long term using, change the axile sleeve
when the sleeve wears down too much.
(五)水泵轴的两个支承是轴承体内的轴承,轴承体内存有适量润滑脂以润滑轴承。
V. Two supportings of water pump axile are bearings in
bearing body.There is some lubricating grease in bearing
body for lubricating bearing.
3.
Installation Base:The soil texture should be firm and solid.
4.
During installation, keep the pump axile in horizontal p ition.
5.The end of
water inlet pipe should be immersed under water in about one meter and far away
from the end of mud in about half meter.
6.After installing the pump,calculate the
suitable suction height and head.Under the stable water level condition,
4、注意填料的冷却情况,填料的的调整,不可太紧,以液体能一滴一滴漏出为准,填料太紧发热、消耗功率。填料太松、使水泵中的液体漏损过多,降低效率。
Pay more
attention to the cooling condition of padding.The padding can not be too tight,
it is ok that the fluid can leak in drops.The temperature will be high if the
padding is too tight which cumes power.If the padding is too loose, the
fluid leaks too much, the efficiency will be lower.
版权所有©2024 产品网