水工及其它方面
机组进水流道设计不合理或与机组不配套、水泵淹没深度不当,以及机组启动和停机顺序不合理等,长治混流泵采购价,都会使进水条件恶化,排涝混流泵采购价,产生漩涡,诱发汽蚀或加重机组及泵房振动。采用***虹吸真空断流的机组在启动时,若驼峰段空气挟带困难,形成虹吸时间过长;拍门断流的机组拍门设计不合理,时开时闭,不断撞击拍门座;支撑水泵和电机的基础发生不均匀沉陷或基础的刚性较差等原因,排污混流泵采购价,也都会导致机组发生振动。
2、水泵起动后有一股水就不出水了
After starting ,
the pump only send one stream water then no water runs out
1、吸入的水中有过多气泡
2、吸水管中窝存空气
3、吸水管或连接处垫料不严密有进气现象
4、底阀或叶轮有水草杂物填塞
1.There are too many bubbles in the
indrawn water
2.There is air in the suction pipes
3.The paddings in connected parts are
imprecision and produces leaking phenomenon
4.There are waterweeds and sundries
filled in the bottom valve or impeller
1、检查进水管末端是否在水平面以下一米左右
2、排除空气
3、高速垫料,填塞缝隙拧紧螺栓
4、消除水草杂物
1.Check the end
of water inlet pipe if it is under the water surface at one meter
2. Remove the
air
3.Add padding to
fill the gaps and then tighten the bolts
4.Clear the
waterweeds and sundries.
轴套用来保护轴不使它与填料直接摩擦,若长期使用中发现轴套磨损过多,必须换轴套。
IV. Axile sleeve is used to protect the axle from friction
with padding.In long term using, change the axile sleeve
when the sleeve wears down too much.
(五)水泵轴的两个支承是轴承体内的轴承,轴承体内存有适量润滑脂以润滑轴承。
V. Two supportings of water pump axile are bearings in
bearing body.There is some lubricating grease in bearing
body for lubricating bearing.
版权所有©2025 产品网