混流泵

8、填料处漏水太多

The padding is

leaking water too much

1、填料压得太松

2、填料装置不好

3、填料大小不一或磨损过多

4、填料质量差，密封性不好

5、轴套磨损太多

1.The padding is pressed too loose

2.The padding does not assemble well

3.The padding is not of niform size or it

wears too much

4.The padding is with bad quality and

tightness

5.

1、上紧压盖到适应程度

2、调整填料搭口，雨水混流泵维修，使之错开一定角度而不在一个方向

3、更换填料

4、更换符合要求的石棉填料

5、更换轴套

1.Tighten the gland up to suitable degree

2.Adjust the padding jiont up to some

angle not in the same direction.

3.Change the padding

4.Change the suitable asbestos padding

5.Change the axle sleeve.

混流泵

2、水泵起动后有一股水就不出水了

After starting ，雨水混流泵供应商，

the pump only send one stream water then no water runs out

1、吸入的水中有过多气泡

2、吸水管中窝存空气

3、吸水管或连接处垫料不严密有进气现象

4、底阀或叶轮有水草杂物填塞

1.There are too many bubbles in the

indrawn water

2.There is air in the suction pipes

3.The paddings in connected parts are

imprecision and produces leaking phenomenon

4.There are waterweeds and sundries

filled in the bottom valve or impeller

1、检查进水管末端是否在水平面以下一米左右

2、排除空气

3、高速垫料，填塞缝隙拧紧螺栓

4、消除水草杂物

1.Check the end

of water inlet pipe if it is under the water surface at one meter

2. Remove the

air

3.Add padding to

fill the gaps and then tighten the bolts

4.Clear the

waterweeds and sundries.

轴套用来保护轴不使它与填料直接摩擦，蛟河市雨水混流泵，若长期使用中发现轴套磨损过多，雨水混流泵安装，必须换轴套。

IV. Axile sleeve is used to protect the axle from friction

with padding.In long term using， change the axile sleeve

when the sleeve wears down too much.

（五）水泵轴的两个支承是轴承体内的轴承，轴承体内存有适量润滑脂以润滑轴承。

V. Two supportings of water pump axile are bearings in

bearing body.There is some lubricating grease in bearing

body for lubricating bearing.

蛟河市雨水混流泵-泰安金石泵业公司-雨水混流泵维修由泰安金石泵业有限公司提供。泰安金石泵业有限公司（www.tajsby.cn）在污水泵、杂质泵这一领域倾注了无限的热忱和热情，金石泵业一直以客户为中心、为客户创造价值的理念、以品质、服务来赢得市场，衷心希望能与社会各界合作，共创成功，共创辉煌。相关业务欢迎垂询，联系人：刘经理。